Dynatech MP-7000 Manuel de service Page 64

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 63
60 9650-0801-01 Rev. A
3 Disconnect multi-wire IBP cable with ferrite
in the area illustrated.
4 Cut the tie wrap to the IBP cable in the area
shown with the orange stick.
Note: During reassembly, secure a new tie
wrap to the IBP cable.
5 Disconnect the USB flex cable from ZIF
connector in the area illustrated.
6 Lay front end of separated unit down with
opened side facing up.
7 Disconnect the black EtCO
2
tube
connector from the air vent.
8 Remove four (4) screws in the areas
illustrated to release the silver EtCO
2
module.
Note: During reassembly, torque screws to
6 in-lbs.
multi-wire IBP cable
Vue de la page 63
1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 91 92

Commentaires sur ces manuels

Pas de commentaire