Dynatech MP-7000 Manuel de service Page 54

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 92
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 53
50 9650-0801-01 Rev. A
Removing the Printer Module
Tools Required
#1 Phillips screwdriver with torque capability
Orange (wooden) stick
Setup
This procedure should be conducted on a static mat.
Wear a wrist strap to ground during the procedure.
To reinstall the printer module, reverse the steps.
Printer Disassembly
1 Place the unit screen down on the mat in a
horizontal position.
2 Open the printer housing and remove the
printer paper.
3 Remove the two (2) screws inside the
printer module in the illustrated areas.
Note: During reassembly, torque screws to
6 in-lbs.
4 Remove the two (2) screws on the outside
of the printer.
Note: During reassembly, torque screws to
6 in-lbs.
5 Slowly remove the printer from the unit,
being careful not to strain the cables.
Vue de la page 53
1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 91 92

Commentaires sur ces manuels

Pas de commentaire